1 PREFACE
Thank you for buying this TV ! Please read this manual thoroughly before operating the
monitor. Make sure the monitor was not damaged in transit. Should the monitor is
damaged, do no install it and contact your dealer. Check that you have all the accessories
according to the model.
2 SAFETY PRECAUTIONS
Preparation
Put the monitor on a stable surface.
Do not use the monitor with others fixations than those provided or
suggested by the manufacturer.
Do not place any material on the monitor.
Do not block or cover the ventilation openings on the monitor
If you have a wall mount, check that it is steady
Power source
The monitor must be plugged with a tension source of 110 volts and
60 Hz.
Connexion cables
Power cord and cables must be properly routed and protected to
prevent people from stepping on them and causing the monitor to
fall.
2
Heating sources and humidity
Keep the monitor dry and away from humidity.
Keep the monitor away from heat sources
Cleaning and maintenance
Unplug the monitor before cleaning it. Do not use solvents or liquids
to clean the monitor.
Only clean the monitor with a soft and dry cloth.
In case of troubleshooting, do not use spare parts other than those
suggested by the manufacturer. Using inadequate spare parts can lead
to electric shocks, short-circuits fire or other incidents.
Departure in holidays
Unplug the LCD during lighting storms or when unused for long
periods of time.
3
3 Front , Back , Connections of LCD
Front View
Back View and Control Connections
4
TV INSTALLTION DRAWINGS
4.1 CONNECTION ANTENNAS
To ensure good picture and sound, TV antenna system needs to be installed. The antenna
system as shown can be sourced from TV equipment shops, which will provide service
for correct installation and connection. After installation, insert the 75-ohm antenna plug
into the antenna jack as shown.In case of signal of closed circuit TV,
4.2 .VIDEO connection
4.3 S-Video connection
5
4.4 PC INPUT connection
VG A
PC Audio
6
5 CONFIGURATION OF THE LCD
5.1 PICTURE SETTING
Press <SYS MENU> key until the screen displays as below.
a) Press ► key to access image adjusting programmer. Press ▲ or ▼ key to select
Picture Mode, Brightness, Contrast, Saturation ,Sharpness and Hue for required
adjusting option.
b) Press ◄ or ► key to adjust the setting selected.
5.2 AUDIO SETTING
Press <SYS MENU> KEY until the screen displays as below.
a) Press ► key enter into audio menu press ▲ or ▼ key to select Sound Mode, Volume,
Bass, Treble and Balance for required adjusting option.
b) Press ◄ or ► key to adjust the setting selected.
7
|